Difference between revisions of "Zaurus"

From Openembedded.org
Jump to: navigation, search
(zaurus-installer)
Line 14: Line 14:
  
 
Multipartitioned cards and lot of filesystems supported.
 
Multipartitioned cards and lot of filesystems supported.
The kernels to be launched are searched in /boot of each available partition.
+
The kernels to be launched are searched in /boot of each available partition as default, but there is a configuration file /boot/boot.cfg allowing to select other kernels, pass a custom cmdline and specify the label and the icon for each.
There is a also configuration file /boot/boot.cfg allowing to select other kernels, pass a custom cmdline and specify the label and the icon for each.
 
  
 
How to install:
 
How to install:

Revision as of 12:07, 26 August 2009

Some technical information about the Zaurus machines from http://linuxtogo.org/gowiki/LinuxDevices

zaurus-installer

For the Zaurus a special kernel+initramfs has been developed. This special-purpose kernel is small enough to be flashed on NAND and features a frambefuffer graphical menu for the selection of the boot media containing the kernel which will be kexec'ed.

Multipartitioned cards and lot of filesystems supported. The kernels to be launched are searched in /boot of each available partition as default, but there is a configuration file /boot/boot.cfg allowing to select other kernels, pass a custom cmdline and specify the label and the icon for each.

How to install:

Just unpack zaurus-installer-YOURMACHINE.tar.gz on a free partition: the package contains the kexecboot-kernel and the updater.sh utility. Then proceed as usual for flashing (switch off, pull battery out, insert battery again, before inserting AC plug press OK+Power On, in the Japanese Menu select 4 and finally 3 for SD card or 4 for CF). Screenshot

For SL-5500 (collie) and optionally for other Zaurus too, flashing is possible just using the routines of the original firmware: reset the unit, Press C, and D button during restart.

See: Flashing-collie