[Openembedded-architecture] bblayers.conf - Past, Present and Future?

[Paul Eggleton]

Hi Trevor,

On Thu, 12 May 2016 09:08:14 Trevor Woerner wrote:
> I often try to start an Angstrom build and then have to go into
> bblayers.conf to disable a bunch of layers because they don't "play nice"
> with each other. Of course bitbake only tells me about them one at a time,
> so I end up having to 1) start a build 2) get an error from bitbake about a
> bad layer 3) edit bblayers.conf 4) goto 1. I usually go through this cycle
> about 5-6 times, then my build can proceed (once the 5-6 bad layers have
> been weeded out).

Can you be a bit more specific about the kinds of failures you're resolving 
here? Are they mismatched bbappends, overridden configuration, ... ?

Cheers,
Paul

-- 

Paul Eggleton
Intel Open Source Technology Centre