[OE-core] [PATCH 1/1] xserver: force to use libdl

[Yu Ke]

on 2011-5-28 16:07, Richard Purdie wrote:
> On Sat, 2011-05-28 at 12:45 +0800, Yu Ke wrote:
>> The marco in question is in xorg-server-1.10.1/configure.ac
>> "
>> AC_CHECK_FUNC([dlopen], [],
>>       AC_CHECK_LIB([dl], [dlopen], DLOPEN_LIBS="-ldl"))
>> AC_SUBST(DLOPEN_LIBS)
>> "
>>
>> Ideally, the dlopen test should fail since dlopen is not available in
>> libc, and then DLOPEN_LIBS="-ldl" is executed. In this case, the later
>> build will correctly link libdl. qemux86 fall into this case.
>>
>> But in ppc case, the dlopen test unfortunately pass, and DLOPEN_LIBS
>> become "", which caused later linker error of unresolved dlopen
>> reference. but I did not yet understand why ppc is so special.
>>
>> For detail, I've attached two config.log, one for ppc, one for qemux86.
>> in ppc,
>> configure:15235: checking for dlopen
>> configure:15235: result: yes
>
> Thanks. If you look at config.log you'll see this near the top:
>
> | #modphp
> | ac_cv_c_bigendian_php=${ac_cv_c_bigendian_php=yes}
> | ac_cv_sizeof_ptrdiff_t=${ac_cv_sizeof_ptrdiff_t=4}
> | ac_cv_func_dlopen=${ac_cv_func_dlopen=yes}
> | lt_cv_dlopen_self=${lt_cv_dlopen_self=yes}
>
> and then if you look at the configure script for the xserver you'll see
> ${ac_cv_func_dlopen} being set to yes is likely triggering the bad
> result.
>
> These are coming from the powerpc site files:
>
> richard at rex:poky/meta/site$ grep dlopen * -r
> powerpc-common:ac_cv_func_dlopen=${ac_cv_func_dlopen=yes}
> powerpc-common:lt_cv_dlopen_self=${lt_cv_dlopen_self=yes}
>
> and I suspect if you remove those two lines, things will work a lot
> better!
>
> Only powerpc has the broken site file which is why only powerpc is
> affected.
>

Thanks Richard. This make sense and explain why only powerpc has this 
issue. I've remove these two line, and build the core-image-sato-sdk 
qemuppc, it passed. I will send out the patch.

Regards
Ke