[oe] Problem with calibration of AT91SAM9M10EKES
Marcin Juszkiewicz
marcin at juszkiewicz.com.pl
Wed Jan 26 13:01:01 UTC 2011
Dnia środa, 26 stycznia 2011 o 10:40:25 Ulf Samuelsson napisał(a):
> I have some calibration problem with my private branch
> (ulf/linux-2.6.30-2011-01-??) when building the at91sam9m10ekes board.
>
> I am running /usr/bin/run-calibrate.sh,
> but regardless of how I click, during calibration,
> a tap afterwards always results in detection 3 mm above the tap.
>
> There is a "pointercal" file generated.
> It appears to me that this is ignored...
> I can tap 1 cm above or below during calibration,
> and still the detected tap is 3 mm above the actual tap.
> Anything else to think about?
> I enclose /etc/X11/xorg.conf and /etc/ts.conf.
You are using full X11 with evdev driver so tslib is not used at all. You have
to use xinput-calibrator.
Regards,
--
JID: hrw at jabber.org
Website: http://marcin.juszkiewicz.com.pl/
LinkedIn: http://www.linkedin.com/in/marcinjuszkiewicz
More information about the Openembedded-devel
mailing list