Difference between revisions of "Zaurus"

From Openembedded.org
Jump to: navigation, search
(How to install:)
Line 19: Line 19:
 
=== How to install: ===
 
=== How to install: ===
  
Just unpack zaurus-installer-YOURMACHINE.tar.gz on a free partition: the package contains the kexecboot-kernel and the updater.sh utility. Then proceed as usual for flashing (switch off, pull battery out, insert battery again, before inserting AC plug press OK+Power On. In the Japanese Menu select 4 and finally 3 for SD card or 4 for CF).
+
Just unpack zaurus-installer-YOURMACHINE.tar.gz on a free (FAT or EXT2/3 formatted) partition: the package contains the kexecboot-kernel and the updater.sh utility. Then proceed as usual for flashing (switch off, pull battery out, insert battery again, before inserting AC plug press OK+Power On. In the Japanese Menu select 4 and finally 3 for SD card or 4 for CF).
 
[http://downloads.conics.net/pda/zaurus-sl-c700/service-menus/maint-menu.jpg Screenshot]
 
[http://downloads.conics.net/pda/zaurus-sl-c700/service-menus/maint-menu.jpg Screenshot]
  

Revision as of 13:11, 26 August 2009

Technical information from LinuxDevices

zaurus-installer

For the Zaurus a special kernel+initramfs has been developed. This special-purpose kernel is small enough to be flashed on NAND and features a framebuffer graphical menu for the selection of boot media containing the kernel to be kexec'ed.

Multi-partition cards and lots of filesystems are supported. The kernels to be launched are searched for in /boot of each available partition. There is a also a configuration file (/boot/boot.cfg) which allows selection of other kernels, custom kernel command lines, and specifies the label and the icon for each instance.

How to install:

Just unpack zaurus-installer-YOURMACHINE.tar.gz on a free (FAT or EXT2/3 formatted) partition: the package contains the kexecboot-kernel and the updater.sh utility. Then proceed as usual for flashing (switch off, pull battery out, insert battery again, before inserting AC plug press OK+Power On. In the Japanese Menu select 4 and finally 3 for SD card or 4 for CF). Screenshot

For the SL-5500 (collie) and optionally for other Zaurus too, flashing is possible just using the routines of the original firmware: reset the unit, Press C and D button during restart.

See: Flashing-collie