[oe] problem with opie for qemuarm
Henning Heinold
heinold at inf.fu-berlin.de
Thu May 7 12:37:30 UTC 2009
On Thu, May 07, 2009 at 02:10:06PM +0200, sledge wrote:
> Hello all,
>
> I have bitbaked opie-image for qemuarm. Resized the resulted
> opie-image.rootfs.ext2 partition, launched qemu with these parameters:
> http://linuxtogo.org/gowiki/Angstrom/qemu-system-arm
>
> I have also tried extracting modules*.tgz into that ext2 rootfs. Same result:
>
> It has configured and launched the init.d processes, stopping any
> output after the bluetooth. Apparently opie did not start, nor any
> other rc processes; hence no graphical interface nor command-line
> login prompt
>
> Where should I start with? I tried to mv etc/init.d/bluetooth
> etc/init.d, but it still starts (thought it was a blocker). I suppose
> it is because the modules are being loaded.
>
>
>
> Thanks!
>
> --
> sledge
Try start qemu with serielle card support and get you login shell via this.
Bye Henning
More information about the Openembedded-devel
mailing list